You can verify this by going to the FrontView’s Status?Health tab. Upon boot-up, your CPU fan should run at the expected speed. See picture below.ĭownload and install the ToggleSwitchProCPUFan add-on in FrontView’s System?Update?Localtab. Move the CPU fan connector from the main board to the IO card. Shut down the system and remove the side panel by taking out the two screws on the back of the unit and sliding the cover back. All that you’ll need is a Phillips screwdriver. If you have one of these systems, you can apply the easy workaround below to restore the automatic fan control. Additional drives are needed to support a RAID 5 configuration.A number of ReadyNAS Pro systems were shipped with the wrong CPU fan cabling which prevents the fan speed from being temperature controlled, thus forcing the fan to run constantly at its maximum speed (in excess of 4000 RPM).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |